Getting Started; Turning The Headset On/Off; Pairing The Headset With Bluetooth Devices; How To Enter Pairing Mode - I.onik entertain BTH-033 Kurzanleitung

The charging procedure is as follows:
Using a USB cable
1. Plug USB charging cable into the USB port of the computer
2. Plug the other end of the USB cable into the headset.
Red light on: Charging
Red light off: Finish charging
3. It will take about 2.5 hours to complete the charging.
note:
1) The battery is recyclable.
2) Batteries (the battery pack or batteries installed) must not
be exposed to excessive heat, such as in the sunshine or
near to a fire.

Getting started

1. Turning the headset on/off

Functions Operation
Turning on Press and hold
MFB button for
3-5 seconds until
blue LED indicator
flashes.
Turning off Press and hold
MFB button for
3 seconds until
red LED indicator
flashes.
note:
In order to save power, the headset will turn off automatically
after 5 minutes if no devices are connected.
24
LED indicator
Blue LED indicator
on for one second.
Red LED indicator
on for one second.

2. Pairing the Headset with Bluetooth Devices

1) How to enter Pairing Mode

Functions Operation
Entering pairing Ensure the head-
mode set is off, and then
press and hold
MFB button for 7-8
seconds until red
and blue LED flash
alternately
note:
Pairing mode will last 2 minutes. If no devices can be connected
after 2 minutes, it will return to standby mode automatically.

2) Pairing the Headset with a Bluetooth Mobile Phone

Prior to using the headset for the first time, you have to pair
it with a Bluetooth-enabled mobile phone. The pairing proce-
dure will vary with different models of mobile phones. Refer
to your mobile phone user's manual for further information.
The general pairing procedure is as follows:
1) Keep your headset and phone within 1 metre when
pairing.
2) Make the headset enter pairing mode (please refer to
"How to enter pairing mode˝).
3) Activate your cell phone's Bluetooth function and set your
cell phone to search for Bluetooth devices within range,
and select "i.onik BTH-033" from the list of devices shown.
4) According to the indication, enter password or PIN
number: "0000".
5) If prompted by your mobile phone to connect, select "Yes"
(this will vary depending on the mobile phone being used).
6) After successful connecting, the blue LED indicator flashes
twice every 4 seconds or flashes 3 times every 4 seconds.
LED indicator
Red and blue LED
flash alternately
25