Kicker ZX300.1 Benutzerhandbuch Seite 3

amplifi er's input level switch to "HI"). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to "LO". Either input
method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to
another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other
power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
Model External Fuse
ZX300.1 1 x 60 Ampere
ZX400.1 1 x 60 Ampere
ZX500.1 1 x 80 Ampere
ZX750.1 1 x 100 Ampere
GND REM +12V
24"
(60cm)
bare-metal
chassis ground
2011 ZX 300.1 400.1 500.1 750.1 RevC.indd 3 2011 ZX 300.1 400.1 500.1 750.1 RevC.indd 3
to amplifi er
shield
Power/Ground Wire
8 Gauge
4 Gauge
4 Gauge
4 Gauge
remote turn-on
(see page 5)
KICKER ZISL
OR
source unit high-level
speaker outputs
KICKER Wiring Kit
PK8, CK8, ZCK8
PK4, CK4, ZCK4
PK4, CK4, ZCK4
PK4, CK4, ZCK4
protection LED
18"
(45cm)
external fuse
12V
to amplifi er
battery
3
11/5/2010 1:22:35 PM 11/5/2010 1:22:35 PM