Control Knobs; Operating Instructions - Zanussi ZGS983ICT Benutzerinformation

Control knobs

Symbol

Operating instructions

Ignition of the burner
Warning! Be very careful when you use open fire in
kitchen environment. Manufacturer decline any
responsibility in case misuse of the flame
Always light the burner before you put cookware.
To light the burner:
1. Turn the control knob counterclockwise to the maxi-
mum position (
2. Keep the control knob pushed for approximately 5
seconds; this will let thermocouple to warm up. If not,
the gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not light, check if
the crown and its cap are in correct positions.
18
Description
no gas supply / off posi-
tion
) and push it down.
Symbol
1 Burner cap
2 Burner crown
3 Ignition candle
4 Thermocouple
Warning! If the burner does not light after 15
seconds, release the control knob, turn it into off
position and try to light the burner again after minimum 1
minute.
Important! In the absence of electricity you can ignite the
burner without electrical device; in this case approach the
burner with a flame, push the relevant knob down and turn
it counter-clockwise to maximum gas release position.
Description
ignition position / maxi-
mum gas supply
minimum gas supply
1
2
3
4
1
2
3
4