Inline 76670I Bedienungsanleitung

Introductions:
USB2.0 PORT to connect PC, SATA PORT to connect 3.5/ 2.5 Inch SATA Hard disk, IDE PORT to connect
3.5/2.5Inch IDE Hard disk, make it become a mobile hard disk, users can access to data freely with high
transfer rate, also it can connect other device which also with SATA/IDE port.
Specifications & Features:
USB specification revision 2.0 compliant
Support data transfer rate: High-speed(480Mbps)/Full-speed(12Mbps) /Low-speed(1.5Mbps)
Compliant to Serial ATA 2.6
Support SATA 1.5Gbps/3.0Gbps speed negotiation
Support 2.5"/3.5" IDE Hard Drive
Support 2.5"/3.5" Serial ATA Hard Drive
Support USB Mass Storage Class Bulk-Only Transport specification
Hot swappable, plug and play
Power Supply: Input:AC 100-240V, 50/ 60Hz
Support Windows 2000/XP/Vista/7/8, Mac 9.2 or higher
USAGE:
1. Check your hard disk USB2.0 TO SATA+IDE Converter and AC power supply are ready for using.
2. Connect the SATA/IDE port of product to hard disk (device with SATA/IDE port).
3. Connect power to product, and turn on.
4. Hard disk will be automatically detected after all connection is ready, then you can access to data.
NOTICE:
1. put product on the desk and insure it is steady after connected with hard disk, and then to connect
to power; don t remove hard disk while it is working, otherwise, data will be lost, even the hard disk
will be damaged.
2. If the system can t automatically detect the device, then you need to format the hard disk use Disk
Management or Disk Utility .
InLine® 76670I
USB 2.0 TO SATA + IDE Converter
USERS MANUAL
Output:DC 12V 2A 5V 2A