Werbung
Verfügbare Sprachen
Verfügbare Sprachen
For the operation of the antenna system BISCAYA it is important that the distribution box AV 205 is
connected to the power supply before (or as soon as) the receiver instruments connected to the AV
205 are switched on; else faulty operation may occur (antenna alarm, incorrect calculation of position,
etc.). The power supply to the antenna system need not be switched on for the operation of the
VHF marine telephone.
Not all receivers are able to handle the antenna voltage from the DELTA 200S without producing
interference. Therefore the output level of the corresponding wideband output can be reduced by
adjusting the associated trimmer potentiometer counter-clockwise until the reception is clear again.
The antenna cables may NEVER be mixed up - otherwise the antenna DELTA 12 M and / or the
distribution box AV 112 will be destroyed!
To guarantee a perfect working antenna it is mandatory to do the installation in a workman-like
manner.
Any faults caused from neglecting these instructions are excluded from the manufacturer's
warranty.
In case of doubt consult a specialist.
Installation of plug-in modules
Two plug-in modules can be inserted into the distribution box AV 205. For retrofitting of plug-in
modules, open the AV 205 case. The plug-in modules have 2 connection pins on one side and 3 pins
on the other side. Insert the plug-in module into the sockets of the AV 205 main board with the 3 pin
end of the module at the output side of the AV 205. Then close the AV 205 case and identify the
association on top of the AV 205 cover using a waterproof marker.
Trouble shooting of antenna system BISCAYA
1.
No function of the entire antenna system
1.1.
Check the power supply - voltage and polarity at the AV 112 and AV 205
1.2.
Check the association of the antenna cables to the antennas, especially at the disconnecting
points at the mastbottom. To make a distinction between the antennas, measure the
resistance of the antenna incl. antenna cable with an ohmmeter:
– DELTA 200 S: 25 - 100 Ohm
– DELTA 12 M: ca. 4,7 kOhm
2.
No function of any instruments connected to the AV 205 incl. VHF
2.1.
Check the cable installation according to the installation plan.
2.2.
Check if the green indicator lamp of the AV 205 and the AV 112 lights.
2.2.1. Indicator lamp lights
Check the cable between AV 205 and the antenna DELTA 200 S for break. Checking the
resistance of the antenna incl. antenna cable with an ohmmeter will indicate 25 - 100 Ohm.
2.2.2. Indicator lamp is off
2.2.2.1. Check the power supply of the AV 205 and the fuse inside the AV 205 (0.5 A medium blow; 5
× 20 mm and 0,16 A flink Ø 5 x 20 mm).
2.2.2.2. Disconnect the antenna at the AV 205. If the indicator lamp lights now, there is a short circuit
at the antenna cable or at the antenna DELTA 200 S.
9.95
Werbung
