Cleaning And Maintenance - Bestron AS1800E Gebrauchsanweisung

user's instructions
Accessories
This vacuum cleaner is supplied with one combined accessory:
• a crevice tool with a narrow nozzle, which you can use to clean radiators,
window frames, crevices, small openings, and similar;
• a small brush, which you can use to clean delicate or irregular surfaces,
furniture, Venetian blinds, and similar.
operAtion - storage after use
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in; the power cord will automatically rewind onto the reel.
Figure 9 Rewinding the power cord
Guide the power cord whilst it rewinds onto the reel, since otherwise the cord could become tangled or
the plug could strike the back of the appliance. Take hold of the power cord near the mark, and allow it
to gently slide through your fingers back into the appliance, see Figure 9.
3. Stand the vacuum cleaner upright. An attachment slot for the accessory bracket is fitted to the back of
the vacuum cleaner next to the front castor (see Figure 10). Slide the bottom of the accessory bracket
into the slot. This avoids the need to dismantle the vacuum cleaner after use; you can
store the assembled appliance and retrieve it again quickly when you need it.
Figure 10 Storing the vacuum cleaner

cleAninG And MAintenAnce

1. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics. Make sure no
moisture gets into the appliance.
2. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
cleAninG And MAintenAnce - changing the dust bag
1. Change the dust bag immediately once the 'dust bag full' indicator turns red, see Figure 11.
It is possible that the indicator turns red whilst the dust bag is not yet full. If so, then the nozzle, hose or
tubes may be blocked. These will then need to be cleaned.
27
Figure 8