Troubleshooting - Skytec 178.530 SPD-10V 10-Zoll USB/VHF Gebrauchsanweisung

OPERATION OF VHF WIRELESS TRANSMITTER
Handheld MIC
Open the battery compartment cover. Insert battery, observing polarity. Re-attach
the battery cover. Turn on the microphone by using the power switch. The battery
LED indicator will light, indicating full battery strength. In the case of a low or dead
battery, the battery LED will extinguish, indicating that the battery should be
replaced with a fresh one. The IR indicator in the amplifier should now be lit. To
preserve battery life, turn the microphone off when not in use. If you are not going
to use the microphone for a long period of time, take out the battery from
microphone to avoid possible battery leakage to damage the microphone.
Note: This unit is supplied with two wireless microphones in two different frequencies which can
be used simultaneously.
TROUBLE SHOOTING:
Failure
NO POWER
NO SOUND
ONE SPEAKER WITHOUT SOUND Connection between master & slave unit wrong
MICROPHONE NO SOUND
MICROPHONE HOWL
This appliance should not be put into the domestic garbage at the end of its useful life, but must be
disposed of at a central point for recycling of electric and electronic domestic appliances. This symbol on
appliance, instruction manual and packaging puts your attention to this important issue. The materials
used in this appliance can be recycled. By recycling used domestic appliances you contribute an
important push to the protection of our environment. Ask your local authorities for information regarding the
point of recollection.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would also invalid
your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the warnings
contained in this manual. Tronios cannot be held responsible for personal injuries caused by a disrespect of the safety recommendations and
warnings. This is also applicable to all damages in whatever form.
Possible cause
The power line is cut off or not connected
No power on the electric outlet
Wrong input, check input selector
The connect line was broken
The volume knob at lowest
Signal line was broke
The microphone not complete connected
Adjust the microphone volume
Change microphone
The microphone is too close to the speaker
Master volume adjust too big