Operation - Skytec 178.530 SPD-10V 10-Zoll USB/VHF Gebrauchsanweisung

OPERATION:

Connect the active speaker with a good quality speaker cable. (21). WARNING: only connected a
original slave speaker on the speaker output terminal!
If required connect an external signal source like a CD-layer to LINE IN.
Connect the device with an electric outlet (220-240VAC / 50Hz)
It is possible to connect an external antenna to the VHF-antenna socket for optimum radio reception.
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input on the rear panel
2. Slide the SOURCE select switch to the correct position.
USB/SD:
1. Slide the SOURCE select switch to USB position.
2. Press PLAY button, MP3 begin to play.
MICROPHONE:
1. Inset the microphone to the MIC1 or MIC2 jack.
2. Adjust the MIC volume and tone control.
3. (Adjust the echo control).
Adjust the master VOLUME (8)
Adjust the master Equalizer (1+3) to get the right sound
WARNING:
Do not turn the volume at max when use this product at public place just like school, office etc. After long time
using the back panel will be hot, do not touch it by hand.
NETHERLANDS , GERMANY
This product should only be used in Germany and the Netherlands (and in Spain / Switzerland with restrictions). In
Germany, the end-user must apply for an individual assignment in a locally relevant branch of the Federal Network
Agency (BNetzA).