AEG MC 4420 CR/USB Technisches Handbuch Seite 66

English
64
3. Via the speakers, you will hear the playback
of the external device.
4. For further procedures, please refer to the
user manual of the external source.
Note:
Adjust the volume of the external device to a
comfortable level.
Record Player Adjustments
Before being able to use the record player, you
might have to adjust some settings.
Horizontal balance and surface pressure
1. Set the ANTI-SKATING
control (22) to "0".
2. Push the tone arm counter-
weight to the end of the tone
arm. Turn the tone arm
counterweight till the keyway
snaps into the furrow.
3. Turn the tone arm counter-
weight clockwise backwards
till the end of the white mark
is reached (Fig.2).
4. Now turn the surface
pressure adjustment ring
till position "1" is above the
line (Fig.3).
MC 4420 CR_USB final IM for GEL 64 64 MC 4420 CR_USB final IM for GEL 64 64
5. Now turn the tone arm
counterweight counter clock-
wise to adjust the weight.
Anti-Skating (22)
The Anti-Skating function counters the pull of
the needle inside.
• Adjust the scale to the same value as the
surface pressure adjustment ring (21).
Record Player operation
1. Set the mode selection switch (9) to PHO-
NO.
2. Open the cover (4) by pulling it upwards on
its front.
3. Put a record on the turntable. When using
a 45rpm single put the adapter (puck) (32),
central axle (30).
4. Unlock the lock of the tone arm support (24)
and remove the needle protection.
5. Set the desired revs with the rpm selection
switch (25).
6. Use the tone arm lift lever (23) to lift the tone
arm. Using the guiding lever (27), guide the
tone arm over the outer edge of the record.
The turntable will start revolving automati-
cally. Use the tone arm lift lever again to let
the needle touch down on the record.
7. At the end of the record, the tone arm will
return automatically to its support. Lock the
holder and attach the needle protection.
Note:
• With some records, the turntable might
stop before the end of the record because
the switch-off point lies outside of the tone
arms radius. In this case, adjust the desired
switch-off point using the adjustment screw
(19).
1. Remove the rubber cover.
2008-10-10 22:21:06 2008-10-10 22:21:06