Operation And Maintenance - Amica KH 17217 E Bedienungsanleitung

Use control panel to control your cooker hood (Fig. 4a / 4b)
KH 17227 E / KH 17228 E / KH 17207E / KH 17208E / KH 17210S / KH 17209S - Fig 4a
- "-" and "+" touch sensors control cooker hood fan speed in the range from 1 to 4,
- "+" touch sensor increases cooker hood fan speed
- "-" touch sensor reduces cooker hood fan speed
- Timer touch sensor activates fan timer (max 90 min.)
- Lights "L" touch sensor switches cooker hood lights on/off independently of fan operation. Press for
a short time to switch on/off lights.
Program function (Timer)
- This cooker hood has a timer function, which controls fan operation. It can be programmed to auto-
matically switch off the fan after 10 to 90 minutes in 10 minutes intervals.
- In order to activate the timer function set the cooker hood fan at a required speed by pressing the
"+" touch sensor and then touch the timer (clock) touch sensor. The display will show a flashing 0
to indicate that timer setup mode is activated. Now select the delay time to switch off the cooker
hood fan by touching ''+'', keeping in mind that the number displayed musts be multiplied by the 10
minute interval (For example 1=10 min, 2=20 min,3=30 min, and so on)
- Once the required delay time is set, confirm it by touching the timer (clock) symbol again. The dis-
play will stop flashing and indicate current fan speed. A small flashing dot by the value correspond-
ing to fan speed indicates that timer is counting down. To cancel the fan timer function, touch the
timer (clock) sensor while the countdown timer is running.
Note: The timer function must be activated within 20 seconds. If no action is taken the cooker hood
will switch to normal operation mode. Electronics protected with a 250V-1.6 A fuse / quick acting
(5x20 glass fuse-element).
When fan and light is off the appliance will automatically go into standby after 20 seconds from the
moment any sensor is touched. Power consumption of the appliance is less than 1W in standby
mode In this mode, the sensor backlight remains off. touch any sensor to resume normal operation
(additional sensor next to the dot on the display).
FILTER SATURATION INDICATOR
The cooker hood is equipped with an electronic filter saturation indicator:
- Replace the charcoal filter – „C" is displayed (220 hours of operation),
- Clean the aluminium filter – „F" is displayed (100 hours of operation),
Neither of these indications affects cooker hood operation, however when C or F is shown, fan speed
indication (0 to 4) is not displayed until the „C" or „F" symbol is cleared.
Touch and hold timer sensor field for about 10 seconds to clear the „C" or „F" symbols.
KH 17217 E / KH 17218 E - Fig 4b
- Press this symbol to switch off motor and light. Once the motor and/or lights are switched on, the
backlight of the sensors will change to red.
- Turn on/off light - sensors backlight will change to red while the light is on
1 / 2 / 3 / 4 - switching on / off the motor - step 1,2,3,4 - backlight changes to red when the motor is
running in first gear, second, third, fourth speed respectively (note: the hood after 5 five minutes on the
4th gear will reduce speed to step 3 )
- Sets the delayed switch-off time. When activated the backlight of the timer symbol flashes.
- Red backlight on this symbol indicates the necessity of replacing the filters. To erase the message
press the sensor field, the red backlight will disappear.
- Boost function switches on automatically every hour for 5 minutes. Note: The main switch (OFF
symbol) switches off the engine and the timer, the light needs to be turned off separately.
The hood is equipped with function Standby. Control Keyboard fades after a few seconds (it indicates
just off icon / off and light icon). To reactivate just touch any icon of control panel.

OPERATION AND MAINTENANCE

15