Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Chapter
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
Guarantee certificate
Please study these instructions, reading them completely and attentively, before using
the unit for the first time. This will guarantee that you will be able to exploit all the
facilities of your new battery charger. The warnings and safety notes are particularly
important. Please store these instructions in a safe place, and be sure to pass them on
to the new owner if you ever dispose of the charger.
In the ULTRAMAT 16 S you have acquired a mature product with an excellent performance. It
incorporates the latest semi-conductor technology, controlled by a high-performance RISC
micro-processor, to provide superior charging characteristics combined with simple operation
and optimum reliability. These features can normally be expected only from much more expensi-
ve units. The ULTRAMAT 16 S represents a reliable method of charging sintered Nickel-
Cadmium (NC, Ni-Cd) packs, Nickel-Metal-Hydride (Ni-MH) batteries, Lithium-Polymer (Li-Po),
Lithium-Manganese (Li-Mn), Lithium-Ion (Li-Io) and LiFePO
and lead-acid (Plumbum: Pb) batteries These sealed, gas-tight batteries have proved excellent
for our purposes in RC models. They are mechanically robust, can be used in any attitude and
are generally highly reliable. They require no special measures for storage apart from protecting
the cells from becoming deep-discharged. The ULTRAMAT 16 S can also be used to discharge
your batteries and balance the cells in a pack.
Note
It is important always to observe the charging instructions supplied by the battery manufacturer,
and to keep to the recommended charge currents and times Do not fast-charge batteries unless
the manufacturer states expressly that they are suitable for the high currents which flow during
these processes. When charging new batteries you may also encounter problems with
premature charge termination. Whenever you wish to use a new battery it therefore makes
sense to carry out a series of monitored test charges, so that you can check that the automatic
charge termination circuit works correctly and reliably with your packs, and charges them to full
capacity.
24
Contents
1. Introduction
4
(LiFe) batteries, and also lead-gel
4
Page
24
25
26
27
27
28
28
29
29
30
31
33
36
38
40
40
42
43
44
44
45
Back cover
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
