Setting Up; Safety Information; Check Contents Of Pack; Connecting The Receiver - AUDIOLINE TEL 5 Bedienungsanleitung

3

Setting up

3.1

Safety Information

NOTE: Before setting up, it is essential that you read the
General Information at the beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one telephone base
one telephone connecting cable one spiral cable
one instruction manual
3.3

Connecting the receiver

After unpacking your telephone, you must first connect the
telephone receiver to the telephone base. First take one end of
the spiral cable and plug it into the socket at the bottom of the
receiver. Turn the telephone over and plug the other end into
the lower socket (see Chapter 2, Section entitled Underside of
base unit, Item 3.). Bring the cable out via the cable duct.
3.4

Connecting the telephone

Connect the telephone cable supplied to the telephone socket
and the telephone jack on the underside of the telephone base
(see Chapter 2, Section entitled Underside of base unit, Item
2.). Then feed the cable out of the telephone housing through
the cable guide either towards the top or the bottom. Secure
the cable firmly in the cable duct.
The telephone works using the MF system (Tone Dialling).
3.5

Wall mounting

Your telephone is also suitable for wall mounting. Use two
screws for fixing to the wall. Drill two holes 85 mm apart,
vertically one above the other, and leave the screws protruding
5 mm from the wall. Now place the telephone base over the
screws and push down slightly.
When the telephone is mounted on a wall, you can hang the
receiver on the telephone without cutting off the call. A small
hook is located at the top of the receiver rest for this purpose.
- Setting up -
one telephone receiver
17