Braun 750 cc-3 Bedienungsanleitung Seite 12

high high
low low
1 1
emp ty emp ty
2 2
new new
high high
low low
empt y empt y
high high high high
low low low low
empty empty empty empty
empty empty
12
q
w
e
r
t
z
u
i
o
p
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
station power socket
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
high high
low low as far as it will go.
empt y empt y
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
high high
«high»
low low
«low»
empty empty
«empty» new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts
shaver will align with the contacts
cleaning station).
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
high high
low low
of the shaver will also be analyzed and one of
the following cleaning program indicators
light up:
Pop-out long hair trimmer
On/off switch
«sensitive» (–) setting button
«intensive» (+) setting button
Reset button
Shaver display
Shaver-to-station contacts
Shaver power socket
Travel case
Special cord set
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
p
, connect the
6
to an electrical outlet.
2
to open the housing.
7
down on a fl at,
1
will show how much
u
on the back of the
3
in the
p
5
will