Installation - Cotech 922206-B Bedienungsanleitung

Installation

• Important: Read the entire instruction manual before installation. Installation should be
carried out by a qualified electrician and conform to current regulations.
• Warning: Make sure that the power is turned off and that the fuse is removed before
beginning any installation or service.
• The floodlight must only be connected to a 230 V, 50 Hz power supply.
• Warning: Make sure that the chosen wall mounting area is free from electrical conduit or
plumbing.
1. The floodlight is intended for fixed installation and should be connected to a circuit protected
by a safety device such residual current circuit breaker (RCCB/RCD).
2. Mark out the position of the mounting holes on the wall using the wall bracket (3) as
a template. Drill holes for the mounting screws. Use suitable screws (and wall plugs if
necessary). The floodlight must be fixed securely.
3. Screw the floodlight onto the wall bracket.
4. The floodlight has 50 cm connection cable. It should be connected to a watertight
connection box (sold separately) with a strain relief (as pictured).
5. Use the connection box as a template to mark out the position of the mounting holes. Make
sure that the mounting surface is flat. Drill holes for the mounting screws. Use suitable
screws (and wall plugs if necessary).
6. Connect the three wires: L Live (brown), N Neutral (blue) and Protective Earth (green/yellow).
7. Tilt the lamp housing to the desired angle and tighten the locking screws (2).
5