Installation; Operation; Sound-Controlled Mode - HQPOWER Varna - RGB 500MW Bedienungsanleitung

6.

Installation

Choose a suitable mounting spot. Mount the fixture in the desired angle using the included bracket.
Connect the power cord to the mains. Disconnect after use.
Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
•
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5 m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
DMX-512 Connection
•
When applicable, connect an XLR cable to the female 3-pin XLR output of a controller (not incl.) and
the other side to the male 3-pin XLR input [7] of the VDP5001RGBLD5. Multiple VDP5001RGBLD5s
can be linked through serial linking. The linking cable should be a dual core, screened cable with XLR
input and output connectors.
•
Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended
number of fixtures on a serial data link is 32 fixtures.
•
A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120Ω
resistor between pins 2 and 3, which is then plugged into the XLR output socket [8] of the last
device in the chain.
7.

Operation

Refer to the illustrations on page 2 of this manual.
7.1 General
1. Make sure the laser projector is turned off. Insert the power plug into the power input [6] of the
laser projector. Insert the other end of the power cable into the mains.
2. To turn on the laser projector, use the on/off switch [4] and turn the safety key [5]. The power
LED [1] lights.
The VDP5001RGBLD5 can be used in the following modes:
•
sound-controlled
•
with a DMX512 controller.
7.2

Sound-Controlled Mode

1. Set all DIP switches [9] to the OFF position to enable sound-controlled mode.
2. Set the microphone [2] sensitivity with the sensitivity knob [3].
V. 02 – 17/09/2012
VDP5001RGBLD5
5 ©Velleman nv