Initial Use; Items Supplied And Transport Inspection; Disposal Of The Packaging; Requirements On The Set-Up Location - Powerfix PHG 2500 B2 Bedienungsanleitung

Initial use

GB
IE

Items supplied and transport inspection

Disposal of the packaging

Requirements on the set-up location

■
■
■
■
■
■
6
The appliance is delivered with the following components as standard:
▯ Heater blower
▯ This operating manual
NOTICE
► Check the contents to ensure everything is available and for signs of visible
damage.
► If the delivery is not complete or is damaged due to defective packaging
or through transportation contact the Service Hotline (see chapter Service).
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces generated waste. Dispose of packaging material that is no longer
needed according to the regionally established regulations.
NOTICE
► If possible, preserve the appliance's original packaging during the warranty
period so that, in the event of a warranty claim, you can package the appli-
ance ideally for its return.
For safe and faultless operation of the appliance the set-up location must satisfy
the following criteria:
The appliance must be placed on a fi rm, fl at and horizontal surface.
Minimum spacings to the housing of 30 cm to the sides, 30 cm above, 30 cm
to the rear and 100 cm to the front must be maintained.
Do not place the appliance in a hot, wet or very moist environment or in the
vicinity of fl ammable materials.
The mains power socket must be easily accessable so that, in an emergency,
the mains power cable can be easily disconnected.
Environment temperature range: 0 to +40°C
Humidity (no condensation): 5 - 75 %
PHG 2500 B2