Troubleshooting - MAC Audio BT FORCE 116 Bedienungsanleitung

PAIRING A BLUETOOTH® DEVICE WITH THE SPEAKER
In order to listen to music, you will need to pair your Bluetooth device with the speaker.
Setting up for the first time
1. Press the power switch to activate the speaker. Press the MODE button repeatedly until the Bluetooth
function is selected. The text „Blue" flashes in the display.
2. Activate the Bluetooth function on your device.
3. Select "BT Force 116" / "BT Force 210" as the device name and enter the pairing code „0000".
4. If the process has been successful and your device is paired with the speaker, the „Blue" display will
illuminate permanently. This indicates that your device is paired and ready for use.
OPERATION VIA THE POWER SUPPLY PLUG
1. Insert the 5.5 mm jack connector of the power supply plug into the power supply socket (DC12V) on the
speaker and then insert the power supply plug into a 230V AC socket.
2. Set the power switch to „ON"
3. Press the MODE button to select the audio source (Bluetooth, SD, AUX)
NOTE: Either use the AUX input with RCA jacks or the AUX input with 3.5 mm jack.
OPERATION IN A VEHICLE VIA THE DC ADAPTER
1. Insert the 5.5 mm jack connector of the DC adapter into the power supply socket (DC12V) on the speaker
and then insert the other end into the vehicle's cigarette lighter.
2. Set the power switch to „ON"
3. Press the MODE button to select the audio source (Bluetooth, SD, AUX)
NOTE: Either use the AUX input with RCA jacks or the AUX input with 3.5 mm jack.

TROUBLESHOOTING

Problem
No power
There is power, but no
sound
Cause
The power supply plug is not
connected properly.
Adjustment of the VOL buttons.
VOL buttons pressed, but still no
sound.
No response of the system
operating buttons.
Remedy
Prüfen Sie Stecker und Kabel des
Steckernetzteils.
Set an appropriate volume.
Check to ensure the correct source has
been selected with the MODE button.
Switch the device off/on.
12