Block PS 100 Bedienungsanleitung Seite 12

6. Place the felt onto the acrylics platter; then place the strobe disc on;
7. Motor house: place the motor feet stands on the top left corner for motor house,
mount the motor feet onto the house body, then stand the motor house on; Use the
measurer for correct position for the motor house; ,
8. Adjust the motor house feet, keep the whole house level at a correct position for
turntable running; Fit the drive belt around the platter and then carefully spread it to
the motor pulley, make sure the motor house is standing without any move to make
sure it is at the correct position for best extension of the belt; then, put the record
clamp on;
Congratulations, audiophiles, set-up finished; now, you got prepared for power
connection of your TT;
Useful tips
The base and the record player should be positioned on a low-resonance surface such
as wood or multiple layer ply board to avoid structural vibration disturbing reply.
Main power connection
1. The turntable is supplied with a power supply suitable or your country's mains
supply. Check the label before connection the power supply to the mains rating in
your house;
2. Connect the low voltage plug from the power supply to the socket on the rear of the
motor house, then connect the power via plug in;
3. Pressing the button ON/OFF will connect the power;