Kontronik JIVE Regler Bedienungsanleitung Seite 18

Programming procedure for all modes (except 6 and 8)
1.
2.
3.
4.
5.
6.
7. Mode tone: ESC switches to every single mode. There is a break between single signal sequences.
8.
9. Attention
: only for Mode 2: For programming a seperate motor-off-position, set throttle to desired
10.
11.
Programming procedure for mode 6
1.
2.
3.
4.
5.
6.
7. Mode tone: ESC switches to every single mode. There is a break between single signal sequences.
8.
9.
10.
11.
www.modellmarkt24.ch www.modellmarkt24.ch
18
Place Jumper on 2 arbitrary of total 3 programming contacts
Connect motor for audio signal
Switch on Tx and Rx. Set throttle to EMF-brake position
Mode 1: one tone, Mode 2: two tones, ... , Mode 11: eleven tones
Set throttle to full speed (front position) if desired mode is reached.
position now. ESC confirms again
Control output: ESC repeats the programmed mode again.
Ready – disconnect battery
Place Jumper on the 2 programming contacts
Connect motor for audio signal
Switch on Tx and Rx. Set the throttle to motor-off-position
Mode 1: one tone, Mode 2: two tones, ... , Mode 6: six tones
Set throttle to full speed (front position) if desired mode is reached.
Set throttle to maximum brake position. ESC confirms again
Control output: ESC repeats the programmed mode again.
Ready – disconnect battery
Connect battery
Wait 2 sec. or
Disconnect Jumper
...
Connect battery
Wait 2 sec. or
Disconnect Jumper
...