End Point Adjustment; Timer - XciteRC XRC 65i Bedienungsanleitung

Function menu

End point adjustment

EN
Channel select End point
End point adjustment or EPA, limits the amount of travel on the servo, or esc. For example, an EPA limit of
50% means that only 50% of the servo/throttle throw is utilized even if the user in put is 100% of the travel
on their transmitter.
To toggle the EPA function, click the UP and DOWN keys simultaneously to enter the system menu, then
click UP or DOWN to scroll to the EPA option; press SELECT to enter the EPA menu, press SELECT again
to select the desired channel and to change its EPA settings by clicking UP or DOWN; after the selection is
finalized, press SELECT to exit to the channel selection, and simultaneously click the UP and DOWN buttons
to exit to the main menu.

Timer

The timer provides audible warnings to the operator in order to control his/her flight time and prolong battery
life.
To set the timer: double click UP and DOWN simultaneously to enter the function menu, then press UP or
DOWN to select the TIM. function; press SELECT· to enter the setting menu and select the time by press-
ing UP or DOWN. After the time has been selected, press SELECT to confirm, then hold down the UP and
DOWN keys to return to the default menu.
Hold UP to start the timer, hold DOWN to reset.
Note:
With 30 seconds remaining, the buzzer will send a short, audible "'beep"' every second and a long extended
"'beep"' when the time runs out; click DOWN to reset the timer, delete the setting or restart the countdown.
30 50501000 Sender XRC 6Si