Sling Guide; Fitting Instructions - Joerns Healthcare OXFORD Benutzerhandbuch

®
Oxford
Journey
• The up and down buttons on the hand control lower and raise the boom correctly.

4. Sling Guide

The Oxford Journey is suitable for patients in the SITTING position. The slings suitable for this
device are listed as follows:
* Oxford Transport sling (various sizes available)
* Oxford Standing sling (various sizes available)
USER GUIDE FOR STANDAID SLINGS
Both the Transport and Standing sling are easy fit slings, suitable for standing and supporting.
They are not a general purpose sling. Patients must always be assessed for suitability by a
qualified person.
Transport Sling

Fitting Instructions

Feed the sling down the back of the patient leaving the top of the commode aperture at the base
of the spine. Check the roll part of the sling is square across the patient's back. Attach the support
strap around the chest of the patient. This strap need not be tight. It is there to hold the sling in
position while attaching the loops to the Standaid. It may be left off altogether if preferred. Ensure
patient's arms are on the outside of the sling (refer to Fig. C, page 13).
10
294000.10050 Rev. B
Attachment Loop
Straps; Shoulder
Chest Supports
and Buckle
Attachment Loop
Straps; Legs
E n g l i s h