Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Solo
®
- Guitar Amplifier
Before you begin to play through your amplifier, it is very important to ensure the
product has the proper AC line voltage supplied. You can find the proper voltage for
your amp printed next to the IEC line (power) cord on the rear panel of the unit. Each
product feature is numbered. Refer to the front panel diagram in this manual to locate
the particular features next to their number.
1
INPUT JACK
1
Use this 1/4" jack to connect your guitar. Connect your guitar prior to turning power on to the amplifier.
OVERDRIVE
2
This knob allows control over the level of overdrive. The Overdrive ON/OFF (3) switch must be
depressed or engaged for you to hear overdrive
OVERDRIVE ON/OFF
3
In the OFF position, the Solo will produce a nice clean sound. Once engaged, look out, this little
amplifier will rock. Use the Overdrive Knob (2) to control the level of Overdrive.
VOLUME
4
This control sets the overall level of the Solo.
LOW, MID & HIGH EQ
5
These controls allow you to dial in high, mid or low tones to your sound.
TAPE/CD INPUT
6
This standard 1/4" input jack allows you to connect a tape or CD player to your Solo and play along.
HEADPHONE INPUT
7
This standard 1/4" input jack allows you to connect standard headphones to the Solo.
When headphones are connected to the Solo‚ the speaker is automatically turned off.
POWER LED
8
This LED illuminates when power is supplied to the Solo.
POWER SWITCH
9
This two-way rocker switch applies power to the unit when placed in the ON position.
Specifications
Rated Power:
12 W(rms) into 8 Ω
Tape/CD Input:
Impedance: High Z, 22 k Ω
Nominal Input Level: -4 dB,
600 mV RMS
ENGLISH
2
3
4
Dimensions (H x W x D):
5
12.625" x 14.0" x 6.875"
32.06 cm x 35.56 cm x 17.46 cm
7
6
7
8
9
Weight:
12.0 lbs.
5.44 kg
Werbung
