Philips LED4 Headlight Handbuch Seite 4

Other Issues
m
• Please ensure that the product comes from a legal sales channel.
• After installation, check that the high and low beams, the flash function, and other electrical equipment
on the dashboard work and that no warnings occur.
• After installation, ensure that the waterproof gasket is fitted correctly to reduce the risk of leakage.
• Do not put the driver box below or under the heating or moving components inside the engine
compartment. This will cause the driver to overheat and cause the LED to not function.
• Do not tie cables to hot or moving components.
• Please ensure that the driver box and cables do not interfere with other components or the engine hood.
• Do not bend the cables excessively, especially near the driver or heat sink area.
Pre-installation Information
2
• Ensure that there is at least 70mm of space behind the headlight fixture and that the fixture has a
diameter of 60mm as shown in Figure 1.
• Ensure that the light fixture has a gasket seal and a metal spring or similar attachment mechanism. Use
the metal spring to attach the bulb as shown in Figure 2.
• Ensure that the LED headlight is in good condition, is not broken or otherwise damaged, and that
there are no scratches on the LED chip surface.
• When installing the LED4 headlight, it is recommended to ask a professional technician to install the
LED4 headlight in a professional workshop or car garage.
• The LED4 headlight may not be compatible with all vehicle types. Before installing the headlight,
please check with a salesperson to confirm compatability with your vehicle.
• After installing the LED4 headlight on your vehicle, please adjust the light axis to the correct position as needed.
• If after installing the LED4 headlight, and the product does not operate as expected, please reinstall
the original bulb.
4
Figure -1
Figure -2
Ф60mm