Technical Data - TECMIX TCG 125 Betriebsanleitung

TECHNICAL DATA

Concrete grinder
Rated power W
No load speed 1/min
Grinding disc
mm
diameter Ø
Spindle thread
Weight kg
Protection class
The data apply to 230/240V rated voltage
Noise and vibration
The measured values were defined according to
EN60 745.
Typical A-weighted noise level of the power tool:
Sound pressure level L =88,7 dB(A)
pA
Noise level L =99,7 dB(A)
WA
Measurement uncertainty K=3 dB (A)
Wear personal hearing protection!
Vibration total values (vector sum of three directions)
calculated according to EN 60745:
Surface grinding (rough grinding):
Vibration emission level a =8,81 m/s
h,AG
2
K=1,5 m/s .
Vibration values stated in these instructions were
measured in accordance with the standardized method
of measurement according to EN 60745 and they can be
used for the comparison of power tools. The method is
also suitable for a provisional assessment of vibration
load.
The indicated vibration level presents the main intended
use of the power tool. However, if the power tool is used
with a different accessory for other purposes, for ex.
cutting, brushing etc., or if it is insufficiently maintained,
the vibration level can deviate. This can increase
vibration load significantly during certain periods of use.
For an accurate assessment of vibration load during a
defined time period, we should also consider periods
when the power tool was switched off or it was
functioning, but not used. This could significantly reduce
data on vibration load during the entire time of work.
Define additional safety precautions to protect the tool
user from vibration impact, for ex. maintenance of the
power tool and its accessories, warming of hands,
organization of progress of work.
Description of electronic versions of diamond
grinder TCG 125
Soft start allows the working speed to be reached
without provoking a reacting torque on starting the
machine, and the maximum speed is achieved after two
seconds. You can start working after that time.
Constant electronic speed adjustment, holds the
speed between no-load and working load nearly
constant.
At short high overloading or long low overloading of the
tool, the built in overload protection electronics limits the
tool's operation, which turns very slowly when the load is
removed or it stops, if it is loaded again.
By switching it off and repeating the starting
TCG 125
procedure the tool will work normally.
1400 Frequent operation of overload protection signifies that
the tool is excessively overloaded and the motor can be
11000
damaged or its service life will be shortened. Besides,
125
excessive overloading will not improve either the speed
or the quality of the work.
M14
We recommend you not to overload the tool in order the
2,8
overload protection will not switch off the tool; this way
II you will protect the tool and the tool's performance will be
higher as grinding discs will be less worn out. We advise
you to cool down the tool under no load for at least
one minute in case of several successive limiting
functions.
DESCRIPTION
Thread for positioning the side handle (2x)
Front handle
Spindle lock-off button
Switch
Protection guard for grinding
Moving part of the guard
Brush ring
Flange
, uncertainty
2
-
Flange nut
Grinding disc
Adequate accessories for cutting and grinding
Use only those accessories that correspond to the data
in the table below.
The allowed speed of the accessory must be equal or
higher than the maximum no load speed of the tool,
indicated in the table below.
Grinding disc
PREPARING THE TOOL FOR WORK
Mounting the auxiliary handle to the tool - Figure 1
Place the front handle
(depending on work) and tighten the screws
handle can be staged at 30 °, adjust work.
115; 125 22,2 11 000
Always disconnect the plug from power
source before making any adjustments or
changing any accessory!
to the desired position
80
. The