Emptying The Ash Tank And Cleaning The Filter Insert; Replacing The Filter Insert; Cleaning The Ash Vacuum; Storing - Wetekom 86 86 90 Bedienungsanleitung

Emptying the Ash Tank and Cleaning the Filter Insert

Clean the filter insert after each use. Empty the ash tank regularly, especially
when the motor loses its suction power. Please note that cold ashes become
incrusted on the filter insert during vacuuming. This will block the filter and the
motor will not be properly aired.
1. First switch off the ash vacuum and pull the power cord before opening the
ash tank.
2. Tap the filter insert carefully to remove the ash from the surface. Preferably
clean the filter insert outdoors by using a hand broom, compressed air or
similar. If necessary, the filter insert can be washed. Wash the filter insert by
hand and allow to air dry fully before using again.

Replacing the Filter Insert

The filter insert is reusable and should be cleaned after each use. Be careful
when cleaning the filter insert; make sure not to damage it. Replace a damaged
and completely worn filter insert with one of the same type.
You can order a replacement filter insert under the article no. 86 87 00.

Cleaning the Ash Vacuum

 Switch off the ash vacuum and unplug from power mains before cleaning the
appliance.
 Clean the housing of the ash vacuum only with a dry of lightly moistened cloth.
Do not use chemicals or abrasives, in order not do damage the sur-
faces. Do not immerse the lid with the motor into water.

Storing

 Store the ash vacuum in a dry and cool place. Do not store the appliance close
to heat sources such as heaters.
 Do not expose the ash vacuum to direct sunlight for an extended time.
Extreme heat will damage the appliance.
Operation
10