To Prevent Damage; Notice For The Blue/White Lead - Pioneer SPH-DA100 Installationsanleitung

Connecting the system

To prevent damage

WARNING
• Use speakers over 50 W (output value)
and between 4 to 8
Ω
value). Do not use 1
for this unit.
• The black lead is earth. Please earth
this lead separately from the earth of
high-current products such as power
amps. Do not earth more than one
product together with the earth from
another product. For example, you
must separately earth any amp unit
away from the earth of this product.
Connecting earths together can cause
a fi re and/or damage the products if
their earths became detached.
• When replacing the fuse, be sure to
only use a fuse of the rating prescribed
on this product.
When disconnecting a connector, pull the
•
connector itself. Do not pull the lead, as
you may pull it out of the connector.
• This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
ACC position
To avoid short-circuiting, cover the discon-
•
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
Refer to the owner's manual for details on
•
connecting the power amp and other units,
then make connections accordingly.
(impedance
Ω
to 3 speakers
Ω Ω
No ACC position
Since a unique BPTL circuit is employed, do
•
not directly earth the
lead or connect the
of the speaker lead together. Be sure to
connect the side of the speaker lead to
the side of the speaker lead on this prod-
uct.
If the RCA pin jack on this product will not
•
be used, do not remove the caps attached
to the end of the connector.

Notice for the blue/white lead

When the ignition switch is turned on (ACC
•
ON), a control signal is output through the
blue/white lead. Connect to an external
power amp's system remote control termi-
nal (max. 300 mA 12 V DC). The control sig-
nal is output through the blue/white lead,
even if the AV source is switched off.
• Be sure not to use this lead as the power
supply lead for the external power amps.
Such connection could cause excessive cur-
rent drain and malfunction.
• Be sure not to use this lead as the power
supply lead for the auto-aerial or aerial
booster. Such connection could cause exces-
sive current drain and malfunction.
side of the speaker
side of another side
Engb
Section
02
5