Philips SBC MC8650 Bedienungsanleitung Seite 2

SBC MC8650_EXPLODED DIGRAM_3
1
2
3
+
-
FM Microphone FM Microphone Receiver
SBC BC8650_ENGLISH_4
ENGLISH
4
FM Wireless Microphone
SBC MC 8650
Congratulations! You have just bought the best RF/FM wireless microphone
system. Philips uses the latest RF/FM wireless technology to give you complete
freedom of movement. No more inconvenient cables and wires!
Legend of Product illustration on inside flap:
FM Microphone
1 Power ON and battery
indicator – Indicator: starts
blinking if battery level is low.
You should then replace the
battery.
2 Power ON/OFF
3 Channel selection (CH A/CH B)
Important
4
Read these instructions: All the safety and operating instructions
should be read before using the wireless microphone system.
5
• Check if the voltage indicated on the type plate of the adapter
corresponds to the local mains voltage before connecting to the
mains power supply.
• Always switch the FM microphone and the receiver to the OFF
position when not in use to save energy.
• Remove the battery from the compartment and disconnect the
adapter from the mains if the system is not in use for long period.
• Batteries contain chemical substances, so they should be disposed
properly.
• Prevent fire or shock hazard: do not expose this equipment to
humidity, rain, sand or excessive heat caused by heating equipment
or direct sunlight.
• Use a slightly dampened chamois cloth to clean the housing. Do
not use cleaning agents containing alcohol, spirits, ammonia or
abrasives as these may harm the housing.
• Radio equipment for wireless audio applications is not protected
6
against disturbance from other radio services.
7
SBC MC8650_ENGLISH_5
FM Microphone Receiver
4 Power ON/OFF and Channel
selection (CH A/CH B)
5 Power ON indicator
6 Microphone signal output
7 DC Power input
HIFI/
KARAOKE
ø3.5MM SET
MONO JACK
- +
ENGLISH
Contents of Box
Your system consists of the following accessories:
1 x SBC MC8652 microphone,
1 x SBC MC8655 microphone receiver
1 x SBC CS030/00 12Volt/200mA adapter (for UK version: SBC CS030/05)
1 x mono audio cable (1m)
1 x 9 Volt battery 6LR61 type, SM544
1 x 3.5mm to 6.3mm mono adapter plug
Installation
Receiver Power Supply
1
Insert the DC connector of the AC/DC adapter into the 12 Volt DC input of
the FM microphone receiver. Always ensure adapter's rated voltage
corresponds to the mains socket voltage.
2 Connect the adapter to the mains supply.
Note: - Only use Philips SBC CS030/00 12Volt/200mA AC/DC adapter
(For UK, use only Philips SBC CS030/05)
- Always disconnect the adapter when you are not using it.
Audio Connections
3
Insert the audio cable to the microphone receiver output and connect to the
microphone input of your HiFi or karaoke system.
> In case your audio source has a 6.3mm microphone input, connect the
3.5mm to 6.3mm mono adapter plug, which is supplied with the set.
Microphone Power Supply
4
Insert a 9Volt battery into the FM microphone battery compartment, with the
correct polarity as shown.
Channel Selection
5
Select the same channel in the microphone and the receiver. The preset
channel is Channel A.
Note: When using 2 FM wireless microphones in the same room, switch one of
the microphone set to Channel B.
5