Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TO SET THE ALARM 2
* Press and hold the
button for 3 seconds:
SET
2
* The alarm2 hour digit will flash, then press
the
button or the
button to adjust to
the desired hour.
* Press the
button, the alarm2 minute
SET
2
digit will flash, then press the
button or the
button to adjust to the desired minute.
* Press the
button to show the current
SET
2
snooze period with the minute field flashes.
* Press the
button or the
button to adjust
to the desire snooze period from 1 minute
to 59 minutes.
* Press the
button and the alarm2 time
2
SET
is set and enabled.
* If no key is pressed for 30 seconds, the clock will
resume the alarm 2 display.
44
LOW BATTERY LEVEL DETECTION
Should the battery capacity drop to a level that is not sufficient to
operate the clock, the low battery indicator will light up. The battery
should be replaced as soon as possible.
Albert Mebus GmbH & Co.
Bergische Str. 11
42781 Haan
RoHS
Attention! Please dispose of used batteries in
an ecologically safe manner.
46
USING THE ALARM AND SNOOZE FOR DAILY
ALARM 1 or ALARM 2
* Press the
1
the alarm 2 on, or the alarm2 off.
AM
PM
* When the current time reaches the alarm time that is enabled, the
corresponding alarm is activated.
D
M
AM
PM
AL2
* Press the
alarm for 24 hours.
* When the alarm is activated, press the SNOOZE/LIGHT button and the
alarm stops but sounds again after the snooze period (4 minutes snooze
AM
PM
period is pre-programmed).
* The repeat alarm indicator will flash.
D
M
AM
PM
* The alarm will stop after 4 minutes if the
AL2
SNOOZE/LIGHT button is not pressed.
AM
PM
RECEIVING THE RADIO CONTROL SIGNAL
The radio-controlled clock will automatically receive the radio signal every
D
M
AM
PM
hour. It will take 3-5 minutes to receive the radio signal. If the DCF signal
AL2
is received, the DCF tower will be visible on the display, otherwise it will not.
TO LIGHT THE CLOCK
Press the SNOOZE/LIGHT button to light up the clock for 3 seconds.
We declare on our own responsibility, that the product:
is in compliance with following norm(s) or documents
/
button to turn the alarm1 on, or the alarm1 off/
SET
SET
2
/
button when the alarm is activated will stop the
SET
SET
1
2
/
SET
1
2
45
Declaration of Conformity
CE
Radio-controlled clock RC89
EN 61000-6-3 : 2001
EN 55014-2 : 1997+A1 : 2001
QA MANAGER : H.Y.WANG
47
button or
SET
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
