EMAK 102-122 Gebrauchsanweisung Seite 114

Operation
2. ENGINE
1)
2.1 Engine oil change
2.2 Air filter cleaning and check
2.3 Air filter replacement
2.4 Fuel filter check
2.5 Fuel filter replacement
2.6 Spark plug contacts check and cleaning
2.7 Spark plug replacement
See the engine manual for the full list and frequency.
1)
At the first signs of any malfunction, contact your Dealer immediately.
2)
The operation must be carried out by your Dealer or a specialized Service
3)
Centre.
General lubrication should also be carried out whenever the machine is to
4)
be left unused for a long period.
6.2.1 Engine
IMPORTANT
Follow all the instructions in the engine
manual.
To empty the oil from the
engine, hold the extension
tube (1) firmly in place and
unscrew the drain plug (2).
When refitting the plug (2)
make sure the seal (3) is
positioned correctly and
tighten it as far as possi-
ble, holding the extension
tube (1) firmly in place.
Hours Completed (Date or Time)
.....
.....
.....
.....
.....
.....
.....
1
2
3
6.2.2 Rear axle
This is a sealed single unit that does not require maintenance. It
is permanently lubricated and its lubricant does not need chang-
ing or topping up.
6.2.3 Battery
The battery must be carefully maintained to ensure long life.
The machine battery must always be charged:
– before using the machine for the first time after purchase;
– before leaving the
machine disused for a
long period;
– before starting up the
machine after a long
period of disuse.
– carefully read and
observe the battery
recharging instructions
in the booklet provided
with the battery. Failure
in following the instruc-
tions or in charging the
battery could perma-
nently damage the bat-
tery cells;
– a flat battery must be
recharged as soon as
possible.
1
1
EN 31