Passion SPAS Anleitung Seite 16

The maintenance of the water is very important with regards to the preservation of your spa, but
even more importantly: your wellbeing. The water balance is dependent on six factors.
1. Alkalinity
Test the alkalinity and k eep the values between 80 PPM and 140 PPM. Use PH-
when the values are under 80 PPM. Use the Total Alkalinity Control (TA+) if the
values are under 80PPM. Read the instructions before use.
2. PH values
Test the PH every day and keep it balanced if necessary. When the PH is higher
than 7.8, use PH-. When the PH is below 7.2, use PH+. Thoroughly read the
instructions on the package. A PH balance that is too low could cause irritation to the
eyes and damage to the spa.
3. Lime content of the water (Calcium)
A low lime content of the water could corrode parts of the spa. A high lime content could
damage spa parts, such as the tub, jets or heating elements.
4. Temperature
The temperature of the water should never be higher than 40° C.
5. Chloride
The chlorine content needs to be at least 0,5 and 1 PPM at most. Read the instructions
before use. Attention: Do not use Trichloro, the warranty becomes invalid when using it.
6. Dissolved substances.
The total of dissolved substances should not be more than 1500 PPM.
The filter needs to be cleaned once a week.
Lastly, a visual check is important. The water should always be crystal clear, without dirty
edges on the sides and it should not smell.
When using the Aquafinesse program, which we heartily recommend, these instructions expire. We
recommend Aquafinesse, because it requires only a few chemicals and is an easy way to
maintain the water in a satisfactory manner.
16