Warranty; Specifications - T.I.P. WDF 10000 Bedienungsanleitung

If you notice an increase in algae formation and/or see that limescale is increasing, you will need to check that the UV-C unit is working properly. To assure peak
Unscrew the cover of the case with the lamp inside and replace the lamp where necessary.
Carefully remove the protective quartz container. To do this, use a wide screwdriver, a coin or similar object, insert the tool in one of the notches that you can see
at the end of the case's threading and lever up the case gently.
Clean the case and protective quartz container carefully using water and a soft rag. Remove any limescale from the quartz tube with descaling solutions. Check
the quartz tube for damage.
Reassemble in the reverse order, making sure you position the O-rings correctly.
Where necessary, grease O-rings with Vaseline.
See page 1 (1a, 2a)
Replacing the UV-C lamp:
Always disconnect the power supply before performing any maintenance work.
Unscrew the cover of the case with the lamp inside, remove the UV-C lamp and replace it with the new one. Reassemble in the reverse order, making sure you
position the O-rings correctly. Where necessary, grease O-rings with Vaseline.
- Water inlet chamber: the coarser debris settles on the bottom of the chamber.
It must be removed using the backwash valve, proceeding as follows:
clear, at which point you can close the valve.
If the valve is clogged, remove dirt inside using a suitable tool.
them in the correct horizontal position. In the two-sponge version, the thinner sponge must always be placed on top.
Annual maintenance:
During winter months, it is best to remove the whole unit, thus avoiding the danger of the unit freezing.

WARRANTY:

This product is warranted against defects in materials and workmanship for a 2-year period from the date of purchase. The warranty does not cover wear parts,
together with the receipt for tax purposes or equivalent document. The owner's remedy under warranty consists in the replacement of defective parts. If improper
use, tampering or negligence can be attributed to the purchaser, user or dealer, the warranty shall become void immediately. The warranty shall also be void in the
absence of a receipt for tax purposes or equivalent document.

SPECIFICATIONS:

MODEL
Mains voltage / frequency
Pump absorbed power
UV-C lamp absorbed power
UV-C lamp life hours
Protection class UV-C lamp
Protection class pump
)
max
Max delivery height (H )
max
Max submersion depth 
Power cable pump
Weight (net)
Maximum dim. of solid particles
For pond up to
Ballast with schuko plug
Dilter dimension (w x d x h)
Hose connection Inlet
Hose connection Outlet
Hose connection back wash
WDF 10000
230 V ~ 50 Hz
55 W
11 W
5,000 Hours
IP 54
IP 68
2,460 l/h
2.5 m
3 m
10 m H05RN-F
7.4 kg
4 mm
) 35°C
max
10,000 l
5 m H05RN-F
46 x 29 x 36 cm
Ø 25 mm
Ø 32 mm
Ø 25 mm
ow or water coming out of the cover, proceed as follows:
For EU countries only
Do not throw electric appliances in your dustbin!
According to EU guideline 2002/96/EG concerning old electric and electronic
appliances and its implementation in national law, such appliances must be
collected separately and fed into an environment-friendly recycling system.
Please consult your local waste management system for advice on recycling.
8
mpletely.
valve until the water is
eir housing, doing your best to keep
through normally.
bstructed.
in the event it is returned for repairs,