Honeywell EMZ 561-HB/MB24 Bedienungsanleitung Seite 14

14 Operating Manual Compact Operating Unit for 561-HB/MB24 / HB/MB24 / MB12
Clearing an intrusion, technical or hold-up alarm
- Enter valid code (min. 5 digits)
- Activate "OFF"
- All LED displays light up and a buzzer signal sounds for approx. 8 seconds
- Stored alarm is cleared
- Detector group LED is dark. Collective alarm LED is dark.
With the combination "self-storing detector" and "always armed detector
group" (e.g. BUS 1 detector base at a technical detector group) clear
twice after triggering.
Clearing a tamper alarm
- Enter valid code (6 digits)
- Activate "OFF"
buzzer signal sounds for approx. 8 seconds. Carry out this procedure twice.
- Stored alarm is cleared.
- Detector group LED is dark. Collective alarm LED is dark.
Changing the personal code
- Enter the personal code twice in sequence and acknowledge with
- The current code is displayed by one-time flashing (0.5 seconds) of the
corresponding "detector group LED". The LED that flashes first, is equivalent
to the first code number.
After the entire represented code appears, there is a pause of 3 seconds
and then the represented code is displayed again.
- Enter new code and confirm with
key for approx. 7 seconds
key for approx. 7 seconds. All LED displays light up and the
Represented code numbers 9 and 0:
Code number 9: Detector groups LED 1 and 8 light up
Code number 0: Detector groups LED 2 and 8 light up
"ON" key.
"OFF".