Electrolux EYB00416SS Bedienungsanleitung Seite 12

10 www.electrolux.com
Step Action
3 Install the tap.
Optional: install the filter.
4
5 Saw a 40mm piece out of the waste pipe.
NOTICE! Make sure the minimal height is 70mm (see image 8).
6 Attach the plastic t-pipe.
Assemble the pressure safety valve.
7
8 Attach the t-piece.
9 Connect the pressure safety valve.
If you are using a filter:
If you do not use a filter:
– Install the tap (B) according to the instructions supplied with the
tap (see image 6).
– If you need a filter, install the filter (E) according to the instructions
supplied with the filter (see image 7).
– When you install the flow meter, mount the flow meter (43) to the
filter according to the instructions supplied with the filter.
– Attach the plastic t-pipe (18) to the waste pase and screw it
hand-tight in place (see image 9).
– Attach the discharge connection (19) to the pressure safety valve
(see image 10).
– Attach the t-piece (15) to the cold water supply and place the seal
(14) in between (see image 12). Use an adapter if needed (not
supplied).
– Connect one end of the filter hose (41) to the t-piece (15) and the
other end to the water inlet of the filter (38) (see image 13).
– Connect one end of the cold water hose (16) to the water outlet of
the filter (42) and the other end to the cold water inlet of the
pressure safety valve (22) (see image 14).
– Connect one end of the cold water hose (16) to the t-piece (15)
and the other end to the cold water inlet of the pressure safety
valve (22) (see image 15).