Setting The Clock; Adjusting The Brightness Of The Display - Yamaha CRXE300 Bedienungsanleitung

GETTING STARTED

Setting the clock

You must set the clock before you use the timer functions.
The clock is based on a 24-hour system.
STANDBY/ON DISPLAY
NATURAL SOUND
STANDBY/ON
TIMER ADJ
TIMER DISPLAY MEMORY AUTO/MAN'L
BASS
PHONES
– +
TIME ADJ
1
Turn on the power by pressing STANDBY/ON on
the front panel, or POWER on the remote control.
2
While the power is on, press DISPLAY to display
the time.
3
While holding TIME ADJ, press HOUR to set the
hour.
• If you want to move the time in the reverse
direction, press HOUR while holding TIME ADJ
and PRESET/BAND.
4
While holding TIME ADJ, press MIN to set the
minutes.
• If you want to move the time in the reverse
direction, press MIN while holding TIME ADJ
and PRESET/BAND.
To display the clock
Press DISPLAY.
The current time appears for about 8 seconds, then the
normal display returns. Some buttons and controls may
not work while the current time is displayed.
Note
• In the event of a power failure or when the AC power cord is
disconnected for more than five minutes, you must reset the
clock.
8
HOUR MIN
VOLUME
CD RECEIVER CRX-E300
TIMER HOUR MIN
MIN
PRESET/BAND
PRESET/TUNING
INPUT
TREBLE BALANCE
– +
L R
PRESET/BAND
Adjusting the brightness
You can adjust the brightness of the display. If you have
connected cassette deck (KX-E300) and/or MD recorder
(MDX-E300) to this unit, the brightness of the displays is
automatically adjusted to that of this unit.
MAX
STANDBY/ON
TIMER
PHONES
Press and hold DISPLAY for about two seconds so that
"Dimmer ±0" appears on the display. While holding
DISPLAY, turn INPUT clockwise to increase or
counterclockwise to decrease brightness.
Control Range: ±0 to –6 (Preset value: ±0)
of the display
DISPLAY
NATURAL SOUND CD RECEIVER CRX-E300
TIMER ADJ TIMER HOUR MIN
DISPLAY MEMORY AUTO/MAN'L PRESET/BAND
PRESET/TUNING
BASS TREBLE BALANCE
– + – +
L R
VOLUME
MIN MAX
INPUT
INPUT