ION iLP Kurzanleitung Seite 4

FEATURES
1. Platter – Place your record here.
2. Counterweight – Controls how much weight
is applied to the tonearm. If the tonearm is
skipping over the record during playback, try
adjusting this counterweight by turning it so it
moves more "into" the tonearm. This places
more weight on the cartridge to help prevent it
from lifting off of the record.
3. Tonearm – The tonearm can be raised and
lowered by hand, or by pressing the raise /
lower lever. Please note that the tonearm
needs to be moved away from resting position
(on the arm clip) for the turntable motor to
activate. When the tonearm is placed back in
its resting position, the turntable motor will
deactivate.
4. Arm Clip – This specially designed arm clip
secures the tonearm while at rest or when not
in use. The arm clip has been designed to remain in the
up position while unlocked.
5. Raise / Lower Lever – Raises and lowers the tonearm.
6. 33 / 45 / 78 Switch* – This switch controls the RPM of
the turntable platter.
7. Autostop switch – This switch turns autostop on or off.
When autostop is on, the platter will start spinning when
the tonearm is placed over the record and stop spinning
when the record has reached the end. (When autostop
is off, the platter will always spin regardless of the
position of the tonearm.)
8. Dock – Connect your iOS device (not included) here to
record audio to it from your vinyl. Please see the
USING iLP WITH YOUR iPhone, iPad, or iPad touch
section of this manual for information on compatible iOS
devices and how to record to them.
9. RCA Output** – The audio from a playing vinyl record
is sent to this line-level coaxial audio output. This must
not be connected to phono level devices.
10. USB Audio Output – Use the included USB cable to
connect your turntable to your computer. The USB
connection will send audio from the turntable to your
computer. Please see the USING iLP WITH YOUR
COMPUTER section of this manual for information.
11. Power – Use the included adapter to connect to wall power.
12. Power Button – Press this button to turn iLP on/off.
7 8
9
IMPORTANT:
cartridge cover (needle cover) before
operating the turntable.
**WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
* If needed, you may adjust the speed of
the turntable platter. On the underside of
iLP, remove
tighten/loosen the appropriate screw with
a screwdriver.
4
DC 12V 1A
Mac/PC
7 3
7 1
7 4
DC 12V 1A DC 12V 1A
11
10
12
Mac/PC Mac/PC
Remove the plastic
the rubber pads
7 2
7 5
7 6
7 7
and