ION CLASSIC LP Kurzanleitung Seite 4

Features
1. Platter – Place your record here.
2. 45 RPM Adapter Holder – Holds
the included 45 RPM adapter.
When not using the adapter, please
place it in this holder.
3. Tonearm – The tonearm can be
raised and lowered by hand, or by
pressing the raise / lower lever.
4. Arm Clip – This specially designed
arm clip secures the tonearm while
at rest or when not in use. The arm
clip has been designed to remain in
the up position while unlocked.
5. Raise / Lower Lever – Raises and
lowers the tonearm.
6. 33 / 45 / 78 Switch* – This switch
controls the RPM of the turntable
platter.
Note: For best results when play-
ing 78 RPM vinyl records, use a 78
stylus (sold separately). Only use a
78 stylus with 78 RPM vinyl records. Purchase the
iCT06rs 78 stylus at ionaudio.com/ict06rs.
7. Autostop switch – This switch turns autostop on or off.
When autostop is on, the platter will start spinning when
the tonearm is placed over the record and stop spinning
when the record has reached the end. (When autostop is
off, the platter will always spin regardless of the position
of the tonearm.)
Note: If your vinyl record stops before it reaches the
end of the music, turn Autostop to the off position for
this particular record. This is generally recommended
for 45 RPM records.
8. RCA Output** – The audio from a playing vinyl record
is sent to this line-level coaxial audio output. This must
not be connected to phono level devices.
9. USB Audio Output – Use the included USB cable to
connect your turntable to your computer. The USB
connection will send audio from the turntable to your
computer. Please see the Using Classic LP With Your
Computer section of this manual for information.
10. Power Cable Input – Use the included adapter to
connect to wall power.
11. Power Button – Press this button to turn CLASSIC LP
on/off.
1
8
IMPORTANT:
cartridge cover (needle cover) before
operating the turntable.
*If needed, you may adjust the speed of
the turntable platter. On the underside of
CLASSIC LP, remove the rubber plugs
and tighten/loosen the appropriate screw
with a screwdriver.
**WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
4
2
3
5
6
7
4
DC 12V 0.2 A DC 12V 0.2 A
11
9 10
Remove the plastic