AEG MMS 4205 Bedienungsanleitung Seite 23

The MP3 player is MMC/SD memory card-compatible (up to 1 GB).
1. Press the SD/MMC card into the opening provided (11) until it clicks into place.
appears in the display.
2. To play a SD/MMC card, please proceed as described under "Playing a Music File".
Please note the following with respect to SD/MMC cards:
Note: If an SD/MMC card is installed, the device automatically switches over to the card
memory ( appears in the display).
• Only the music tracks available on the selected storage device are played back. For
example, after playing back the music tracks on the SD/MMC card, the device does not
change automatically to the in-built fl ash memory (see next paragraph).
Moving between the internal fl ash memory and the SD/MMC card
With the device in stop mode, keep the EQ key (12) pressed down to switch between the
internal storage device (SEL FLASH appears briefl y in the display) and the installed memory
card (SEL Sd-C appears briefl y in the display).
Notes on how to insert the SD/MMC card:
The card is inserted into the slit in such a way that no part of the card protrudes out. Do not
use excessive force to insert the card, so as not to damage the SD/MMC card or the built-in
card slot.
If the MP3 player can not read the SD/MMC card, it may have to be reformatted to FAT. In
order to format the SD/MMC cards, please proceed as described in the operating software
of your PC.
Note: When using a SD/MMC card in the MP3 player the power consumption increases.
Problems may occur when you attempt to switch on the MP3 player with an installed
SD/MMC card. If this is the case, insert a new battery. To save on battery power, remove the
SD/MMC card when not in use.
Removing a SD/MMC card
Ensure that the MP3 player is switched off. Press the SD/MMC card again in order to
remove it.
05-MMS 4205 AEG 23
Installing a SD/MMC card
(not included)
14.06.2006, 9:00:40 Uhr
23