LG F14W7QDN1H Bedienungsanleitung Seite 16

3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
plate .
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release the
connector latch plate. Make sure the adapter locks
into place.
Latch plate
NOTE
• After connecting the supply hose to the water tap,
(dirt, sand, sawdust, and etc.) in the water lines. Let
the water drain into a bucket, and check the water
temperature.
Connecting Hose to Appliance
Attach the cold water line to the cold
water supply on the back of the washer.
Cold
water
supply
NOTE
• After completing connection, if water leaks from the
hose, repeat the same steps.
Use the most conventional type of tap for the water
supply. In case the tap is square or too big, remove
the guide plate before inserting the tap into the
adaptor.
Using the Horizontal Tap
Horizontal tap
Extension tap
Square tap
EN
15