Operation - AirStage UTY-LNH Bedienungsanleitung

OPERATION

To Select Mode Operation
1 Press the START/STOP button.
The receiver unit control panel's OPERATION Indicator Lamp (green) will
light.
The air conditioner will start operating.
2 Press the MODE button to select the desired mode.
Each time the button is pressed, the mode will change in the following
order.
s AUTO
HEAT
About three seconds later, the entire display will reappear.
*1 "AUTO" can be set only in the indoor unit assigned to the repre
sentative indoor unit.
*2 "FAN" cannot set to heat pump type.
To Set the Room temperature
Press the SET TEMP. button.
button: Press to raise the thermostat setting.
button: Press to lower the thermostat setting.
G Thermostat setting range:
AUTO .................................. 18-30 °C
Heating ............................... 16-30 °C
Cooling/Dry ........................ 18-30 °C
The thermostat cannot be used to set room temperature during the FAN mode (the
temperature will not appear on the Remote Control Unit's Display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN button.
Each time the button is pressed, the fan speed changes in the following order:
s s
AUTO
About three seconds later, the entire display will reappear.
When set to AUTO:
Heating: Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the temperature
of the air issued from the indoor unit is low.
Cooling: As the room temperature approaches that of the thermostat setting,
the fan speed becomes slower.
Fan: The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation and at the start
of the Heating mode.
En-5
9379143004-03_OM_en.p65
*1
s COOL s DRY
*2
t t
FAN
s s
HIGH MED LOW
5
Example: When set to COOL.
Example: When set to 26 °C.
Example: When set to AUTO.
13/3/09, 10:05