Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Never use the unit to vacuum flammable or toxic substances (e.g. benzene, asbestos, asbestos dust, toner for copying mach ines) or
•
volatile substances, acids, hat or burning ashes, dust, sand or similar dirt
Never use the unit in the vicinity of explosive fluids or vapours.
•
The unit is not explosion protected.
•
Compare the electrical values of the power supply with those on the type plate on the packing or on the unit itself.
•
Obey absolutely valid regulations on the electrical security
•
Never run this device dry
•
Pumping inflammable, as well as all other aggressive liquids is prohibited
•
Keep the power plug and all connection points dry!
•
Do not operate or leave the unit in the rain.
•
During longer unused times, clean the pump, wash it out with clear water, dry and store it at room temperature
•
The pump is to be secured / protected through a RCD circuit breaker (release current 30 mA)
•
The electrical connections are always to be carried out by an authorised professional
•
The manufacturer explains:
To take over no responsibility in the case of accidents or damages on the basis of carelessness or disregard to the instructions in this
•
book.
To reject every responsibility for the damages which originate from the improper use of the pump
•
5. MAINTANCE
Switch the unit 0ff with the main switch and pull the power plug.
1.
Remove all hoses and the motor housing.
2.
Thoroughly rinse the collection container.
3.
Remove the foam filter and clean it with clear water.
4.
Check the foam filter and, it damaged, replace this wearing part by an original Pisces foam filter.
5.
Always check the float switch for ease of movement.
The following controls should be carried out regularly:
Intactness of the electrical cable
•
That the connection hoses are not bent or broken
•
Cleanness of the medium (no mud, see technical data)
•
Moreover, the pump should be emptied with danger of frost, be washed out with clear water and stored dry.
•
6. STORAGE
Drain the collection container and store the unit at in dry, frost-free place inaccessible to children.
8. GUARANTEE REGULATIONS
For all manufacturer defects and material defects we grant the statutory guarantee time (new and unused product). In such cases
we take over the exchange or the repair of the equipment. Forwarding expenses are not carried by us.
The guarantee is not valid with:
Material wear (sealing rings, impeller wheels, impeller chambers)
•
Unjustified interventions or changes in the pump
•
Damages by selffault
•
Improper servicing and improper use
•
DRY RUN (Also partially!)
•
Moreover, we give no damage compensation for secondary damages!
9. TROUBLESHOOTING
Problem
Drain hose fitted incorrectly.
The device does not sucks
The unit is too high above the water.
Foam filter, suction tube, suction hose or fine
filter bag dirty.
The suction power will diminish.
The filter bag is full.
Drain hose kinked or laid without gaps.
This device is not discharged.
Collection container and outlet hose dirty.
3
Possible cause
Solution
The butterfly valve in the drain hose must be
located at the outlet of the drain hose.
The machine should be max. 0.5 m above the
water level up.
Clean the device (see Maintenance).
Filter bag exchange.
Drain hose without kinks and with a slight
gradient embarrassed.
Collection container and drain hose to clean.
Inhaltsverzeichnis
1.
Vorwort
2.
Allgemeines
3.
Inbetriebnahme
4.
Sicherheitshinweise
5.
Wartung
6.
Garantiebestimmung
7.
Erkennen und Beheben von Fehlern
8.
Technische Daten
Regen-Tec GmbH
Hilderser Strasse 11
DE 98590 Schwallungen
Tel.: (+49) 36848-40928
Fax: (+49) 36848-40571
info@regen-tec.de
www.regen-tec.de
DEUTSCH
5
5
5
5-6
6
6
6
7
Impressum
4
Werbung
