Cabletech URZ0194 Bedienungsanleitung Seite 45

Owner's manual
heat register. This video product should not be placed in a built-in installa-
tion such as a book case or rack, unless proper ventilation is provided or the
9. Attachments- Do not use attachments unless recommended by the video
product manufacturer as they may cause hazards.
10. The apparatus shall not be exposed to dripping or splashing and that no
Caution: Maintain electrical safety. Powerline operated equipment or acces-
features. This will help avoid any potential hazard from electrical shock or
11. Accessories- Do not place this video product on an unstable cart, stand,
tripod, bracket, or table. The video product may fall, causing serious injury
to a child or adult as well as serious damage to the video product. Use this
video product only with a cart, stand, tripod, bracket, or table recommended
accessory recommended by the manufacturer.
12. A video product and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the video product
and cart combination to overturn. Note to CATV system installer This re-
820-40 of the NEC which provides guidelines for proper grounding and, in
ing system of the building, as close to the point of cable entry as practical.
13. Outdoor Antenna Grounding- If an outside antenna or cable system is
connected to the video product, be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and built-
up static charges. Section 810 of the National Electrical Code, ANSI/NFPA
No.70-1984 (Section 54 of Canadian Electrical Code, Part1) provides infor-
mation with respect to proper grounding of the mast and supporting struc-
ture, grounding of the lead-in wire to an antenna discharge unit, connection
to grounding electrodes, and requirements for the grounding electrode.
13a. Power Lines-An outside antenna system should not be located in the
vicinity of overhead power lines, other electric light or power circuits, or
where it can fall into such power lines or circuits. When installing an outside
-
-
EN
45