TFA 60.2503 Bedienungsanleitung Seite 7

TFA_No. 60.2503 Anleitung
Radio controlled alarm clock with thermometer
K: / °C/°F button
L: WAVE button
M: RESET button
N: AUTO-LIGHT slide
O: Battery compartment
3. Getting started
• Pull off the protection foil on the display.
• Remove the battery insulation strip.
• The clock will scan the DCF frequency signal and the DCF symbol
flashes on the LCD. When the signal is received successfully after
3-10 minutes, the radio controlled time and the DCF symbol
appears permanently.
• If the reception fails, scanning stops and will be repeated every
hour.
• The clock is able to scan the time signal manually by holding
WAVE button 3 seconds.
• In case the clock cannot detect the DCF-signal (for example due to
disturbances, transmitting distance, etc.), the time can be set man-
ually. The clock will then work as a normal quartz clock. (see 4.1
Setting of clock, time zone and calendar).
12
29.06.2009 15:15 Uhr Seite 7
Radio controlled alarm clock with thermometer
4. How to operate
4.1 Manual setting of clock, time zone and calendar
• Hold MODE/SET button in normal mode. The hour digit is flashing.
Press or button to adjust hours.
• Press MODE/SET button and the setting sequence is shown as fol-
lows: Minutes, seconds, year, month/day or day/month sequence,
month, date, timezone and day-of-week language. Press
buttons to make the desired settings
• Confirm with MODE/SET button.
• Display of date day/month (DM) or month/day (MD): In "month/
day sequence" the two different date displays can be selected:
Month/date (M/D, American version) or date/month (D/M), Euro-
pean version).
• The time zone is used for countries where the DCF signal can be
received but the time zone is different from the DCF time (e.g.
+1=one hour later).
• Day-of-week language: German (GER), Netherlands (NET), Polish
(PL), Czech (CZ) and English (ENG).
• Holding or buttons, you will enter fast mode.
• The instrument will quit automatically the setting mode, if there is
no button used within 30 seconds.
• The manually set time will be overwritten by the DCF time when
the signal is received successfully.
or
13