Installation - Respekta EB 6000 IX + KM 7000 IX Bedienungsanleitung

This appliance complies with the current European safety legislation.
We do wish to emphasize that this compliance does not negate the fact
that the surfaces of the appliance will become hot while operating
and will retain and emit heat even if it has stopped operating.
Do not use a socket board or a multi socket when using 220–240 V/50 Hz
alternate current (AC).All electrical connections which may be damaged
All repairs should be performed by your authorized after sales service.
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use
any aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
5. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
6. Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
7. Connect the appliance to the mains properly.
8. The nameplate is situated inside the appliance or at the back.
While unpacking, the packaging materials (polythene bags, polystyrene pieces, etc.)
should be kept away from children. RISK OF CHOKING

4. INSTALLATION

must be repaired by a qualified professional.
Unpacking and positioning
WARNING!
Warning!
34