Basic Operation - US Blaster USB-7303 Handbuch

BASIC OPERATION

Loading and ejecting the disc
* Press the "OPEN" knob to open the disc compartment door.
Symptom
Door can not be opened when the
OPEN button is pressed.
When playback is started, stops or
* Load disc Correctly place a disc in the center of disc compartment with the label side up not to place
pauses immediately.
more than one disc.
No sound
Sound is distorted
* Push the door in to close it.
* Press the PLAY/PAUSE button to start the playback.
Hum
2. Track skip
Use the TRACK SKIP control to advance (
3. FRAME SEARCH
* JOG DIAL
In pause mode, dial the jog, the playback will move by frame or frames depending on the speed you dial.
* SEARCH KNOB
Press the search control (
the control, it will move rapidly with sound.
6 Copyright U.S. Blaster Europe BV - Delft - Netherlands
Cause
Power plug is not connected properly.
*Disc is loaded upside down.
*Dust or dirt on the disc.
*Output cables connected
unproperly.
*Audio mixer operated unproperly.
*Pin plugs or amplifier terminals are
dirty.
*Player is in pause mode.
*Incorrect connection.
*Pin plugs or amplifier terminals
are dirty
Cable connected unproperly.
) or reverse (
or ) in pause mode to move by one frame per press; keep pressing
Remedy
Correctly connect the plug.
* Load the disc with label side up.
*Clean the disc and load it again.
*Connect the cable properly.
*Check the setting of audio mixer.
*Press the PLAY/PAUSE button.
*Connection with audio mixer to
the LINE INPUT terminals.
* Clean away the dirt.
* Firmly connect all audio plugs.
) to a desired track.