SOLARA Starter PACK Montageanleitung Seite 12

-
+
1
Charger
2
Bord battery
Fig. 1: connection principle 1 panel
Connecting two solar panels in parallel:
Connect the solar panels to the MultiContact
Y-plugs and connect the plugs using the DC-
connect-C connecting cable (panel/charge
controller, see fig. 2). If the distance between
the panels is too large, please use the DC-
connect-M connecting cable. Fix the plugs
to the panel frame using a zip tie. In doing
so, please make sure that the plugs will not
come in contact with backed-up water.
Connecting two solar panels in series:
Connect the plug of the first panel with the
plug of the second panel. If the distance bet-
ween the panels is too large, please use the
DCconnect-M connecting cable (panel/panel,
s. fig. 3). Open plugs of the panels can now
be connected using the DCconnect-C con-
necting cable(panel/charge contoller). Fix
the plugs to the panel frame using a zip tie.
In doing so, please make sure that the plugs
will not come in contact with backed-up water.
12
1 DCconnect-C
connecting cable
2 DCconnect-B
connecting cable
2
Starter battery
-
+
+
3
4
5
3
1
Charger
2
Bord battery
Fig. 2: connection principle 2 panels in parallel
Guidelines for installation and handling
of the ABS mounting spoilers
Although this product has been designed
to be sturdy, it is advisable to handle it with
care.
The spoilers have to be mounted in such a way
that no airflow can reach under the panels.
Use only the componets of the SOLARA FIX
PACK to glue the ABS mounting spoilers.
Always keep the mounting system flat (do
not bend, twist, etc.).
It is necessary to pre-treat the surface to en-
sure optimal bonding results.
Preparing the surface/installation
Oil, fat and other dusts must be completely
removed from the surface to ensure proper
adhesive bonding.
-
1 DCconnect-C
connecting cable
2 DCconnect-B
connecting cable
3 DCconnect-M
connecting cable
4 MultiContact
Y-plug +
5 MultiContact
Y-plug -