Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HARDWARE
1.
GENERAL
The manual is a part of the scope of supply and serves to ensure proper handling and
optimum functioning of the instrument.
E+E Elektronik
publication nor in case of improper treatment of the described products.
For this reason, the manual must be read before start-up.
In addition, the manual is for all personnel who require knowledge concerning transport,
setup, operation, maintenance and repair.
The manual must not be used for the purpose of competition without a written consent from
E+E Elektronik
Copies for personal use are permitted.
The document may contain technical inaccuracies and typographical errors. The content will
be revised on a regular basis. These changes will be implemented in later versions.
The described products can be improved and changed at any time without prior notice.
© Copyright E+E Elektronik
1.1
Symbol assertion
This symbol indicates a safety instruction.
These safety instructions should always be followed carefully. By not following these instructions
injuries of persons or material damage could happen.Therefore E+E Elektronik
This symbol indicates a note.
These notes should be followed to achieve optimum functioning of the equipment.
1.2
Safety instructions
•
•
•
•
Hold the sensor on its connection wires only.
•
2.
MODELS
EE08 with cable
EE08-PFTxExxx
25
(0.98")
®
Ges.m.b.H. doesn't accept warranty and liability claims neither upon this
®
and must also not be forwarded to third parties.
Extreme mechanical stress and improper use must be avoided.
Be careful when removing the filter cap to avoid damage of the sensor element.
The sensor is an Electro Static Discharge sensitive component (ESD). When
touching the sensor element, ESD protective measures should be followed.
Installation, electrical connection, maintenance and start-up procedures should be executed
by qualified technical personel only.
61
(2.4")
73
(2.87")
®
Ges.m.b.H.
EE08 with connector
EE08-PFTxDxxx
M12x1
12
All rights reserved.
®
does not accept liability.
83
(3.27")
M16x1.5
61
connector M12
(2.4")
(8-pole)
71
(2.8")
Werbung
Inhaltsverzeichnis
