Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Caution: In use, surfaces will get hot. Danger of getting burned! Do not splash cold water on the hot glass
surface!
Children and persons with handicaps of physical, sensorial or mental nature must not operate this appli-
ance without an adequate supervision and/or corresponding expert advice and safety instructions.
Children should be supervised in order to ensure that they do not play with this appliance.
Do not at all operate this unit with an external timer or a separate telecontrol system.
In case of signs of damage to the appliance, the power cord or the sealing, or if the glass plate is broken,
immediately unplug the appliance.
In use the power cord – as well as those of any other neighbouring electrical appliances - must not touch
any hot parts of the appliance.
Do not use the appliance as a space heater. The safest way to switch the appliance off is to unplug the
mains plug.
Never immerse the appliance in water and take care that no steam can infiltrate it.
Our electrical appliances comply with the relevant safety regulations. Should the appliance, the glass sur-
face or the power cord be damaged, immediately unplug the mains plug. Repairs may only be carried out
by authorised specialist shops. Improper repairs may result in considerable dangers for the user!
Initial use and operating instructions in general
Caution: The appliance has a high-quality glass surface. Please be sure to place kitchenware carefully onto
the plate and not to slide it on. Hard china may cause scratches.
•
For maximum effectiveness it is sensible for the hot food to be placed in containers which have been
preheated already. For this purpose, place the heat-resistant containers and trays on the cold hot tray
and turn it on.
•
The preheating time should be at least 15-20 minutes.
•
Ensure not to expose the glass to any excessively heavy temperature fluctuations. Therefore, put con-
tainers with hot foods only on the preheated appliance.
•
To keep food warm, kitchenware with bottoms resting well on the surface are particularly suitable. The
bigger the surface, the better the heat transfer. The bottom edge to be placed on should not be too
high, as this will otherwise induce more considerable heat losses. Covering the food allows for it to be
kept warm yet more efficiently.
•
Larger quantities of food in a high container should be stirred and re-shifted time and again in order
for the food to be kept warm evenly.
•
The appliance is not suited for warming up, defrosting or cooking food.
Models WP 250 & WP 350, WPR 305/E & WPR 405/E
•
For a start, connect the safety plug to an earthed electrical outlet.
•
Then switch the appliance on with the rocker switch. The pilot lamp integrated in the switch will come
on, indicating that the hot tray is turned on.
•
The models WPR 305/E and WPR 405/E are additionally equipped with a thermostat which allows for
infinitely variable temperature regulation.
•
After use, switch the appliance off again and pull the mains plug!
Model WPE 308/TC with Touch Control
Installation
The hot tray is designed for installation into work tops with a thickness of 3 - 4 cm. Installation as well as
repairs of the appliance must be made by authorised specialists only. Otherwise there might be conside-
rable danger for the user. Always unplug the appliance prior to each examination! The manufacturer does
not accept any liability for faulty function caused by improper installation.
The recessed gap must have a sufficient distance (at least 5 cm) to the back and side walls in order to
avoid overheating. On one side, a high cabinet can be added, however at least two sides must be kept
free in order to assure unhindered air-circulation. A distance of at least 1.5 cm must be left underneath the
bottom edge of the appliance, access from the bottom must not be possible.
Please take care that with built-in furniture the synthetic coating and the veneer respectively have to be
affixed with heat resistant glue (100° C).
Before mounting, the recess in the work top has to be cut out according to illustration A.
If two or more hot trays are installed side by side, a distance of at least 5 cm has to be left breadthways
4
Werbung
