HAPRO Luxura V7 Anleitung Seite 10

Fault reporting:
Error!
Internal timer is defect
Error!
Overheating door(s).
Error!
Communication fault between control and switch parts
Reading out the Counters:
+
In order to read out the counter of the tubes, the "stop" button and the "body cooling higher" button must be pressed
simultaneousl y for three seconds.
Body cooling higher
A
Timing indicator x 10 = working hours tubes
Example:
B
A. 759 hours is indicated as 75
B.
By pressing the "body cooling lower" button for 10 seconds, the counter is reset at 0 hours.
Body cooling lower
+
The counter for the entire machine gives the total number of hours, including the ventilation time. By pressing the "stop and body
cooling lower" buttons simultaneousl y for three seconds, the timer can be read off the display.
Body cooling lower
C
Timing indicator x 10 = working hours tubes
D Example:
C. 759 hours is indicated as 75
D.
Note: This timer cannot be reset to "0" .
Note: If a fault is reported, the electronics will give off bleep tones to alert you.
If one of the abovementioned faults appears on your display, you must not use the machine and remove the
plug from the socket. Contact your dealer for more guidance.
9760 is displayed alternatel y with 1 second intervals as: 9 - 76 - 9 - 76
9760 is displayed alternatel y with 1 second intervals as: 9 - 76 - 9 - 76
- 10 -