CareTech CareIP Mobile Benutzerhandbuch Seite 20

Connection
The CareIP Mobile is easy to install, if broadband/network connection shall
be used, connection is made with the enclosed network cable.
Normally the CareIP is set to use DHCP, which means that the unit
automatically will be assigned an IP address when connected to a network.
The CareIP should always be connected to the network as near incoming
broadband as possible.
Connect the power supply
•
lead to the DC input socket
Connect the network cable
•
Ethernet socket
Turn the power switch
•
Check that the "ON"
•
The status light
•
Carry out a test alarm from the CareIP.
•
The power supply shall be placed so the information text
"Do not to unplug" is visible.
For further advice regarding installation, contact your supplier.
Installation must be performed only by authorized persons in
accordance with the instructions in the service manual.
Connectors on the back of the unit
1 1 1 1
on CareIP
to the
indicator lamp has a steady green light.
shall go off within 30 sec. if GSM network is detected.
to the wall socket and the power supply
1 1 1 1
.
2 2 2 2 from the broadband/network to the
position.
I
20
2 2 2 2