Initial Settings; Quick Edit - Korg Pandora px5d Bedienungsanleitung

Initial Settings

1
When you finish making connections, set the power
switch to the "ON" position. (This setting is referred
to as Play mode.)
Use the π/† CURSOR to select a program.
2
Set the input level switch depending on the output
level of your guitar or bass.
HI: High-output pickups (e.g., humbucking or pick-
ups with a preamp)
LO: Low-output pickups (e.g., single-coil type pick-
ups)
3
Set the volume control of your guitar or bass to its
usual position. Use the Value encoder to adjust the
master level.

Quick Edit

In each mode (except when Mute/Bypass or Key Lock
are active), you can use the Control dials to adjust the
gain, tone, or volume of amp modeling. When you move
a control dial, the parameter name and value will appear
for several seconds in the value display. If the setting
matches the original setting, the ORIG icon will light.
The Delay Time can also be set by pressing the TAP/BY-
PASS button twice at the desired interval (except when
in Rhythm & Bass mode).
When you set the delay time, the value display will in-
dicate the delay time for several seconds.
Amp gain, tone, and volume
Program
name
Program
selection
Settings that you make using Quick Edit will return to
the original saved settings if you change programs or turn
off the power before Writing (☞p.31 "WRITE").
Input level switch
Master level
adjustment
Set the
delay time
Program
number
15